Our Projects:

Chatham Rock Phospate project


Since assisting Chatham Rock Phosphate Limited (CRP) prepare and lodge its initial prospecting licence application in 2007, Kenex has maintained significant involvement in this exciting and unique project.

The Chatham Rise is a large underwater plateau lying east of New Zealand. Extensive phosphate (P2O5) deposits occur along 400km of the crest of the Chatham Rise at water depths of 400m or less. The phosphate is formed in nodules which are typically 10-40mm across but can vary from 1mm to over 150mm in diameter and are in a sandy layer up to 70cm thick.


The deposit was formed 7-12 million years ago. It was discovered by New Zealand scientists in 1952 and then subsequently investigated by private companies and government researchers from 1975 to 1981. Extensive sampling and geophysical surveys conducted during this period means the deposit is well defined, with approximately 25 million tonnes of P2O5 identified in the most intensely sampled area (now converted to a mining permit by CRP), but is likely to be much more in the broader area of interest to CRP.


The project is of one of New Zealand's most exciting resource projects for many years. Studies to date indicate the rock phosphate can be extracted using existing technology for much less than the cost of buying and importing it from Morocco (where much of the phosphate for use in New Zealand fertiliser manufacture is sourced from). Successful extraction could result in a much reduced carbon footprint from the New Zealand fertiliser industry as all imported rock phosphate is presently shipped from the other side of the world. Sourcing this resource locally would significantly improve New Zealand’s balance of payments by reducing imports. Chatham Rise rock phosphate may be more environmentally friendly as a fertiliser where it is applied directly to pasture with previous Government studies indicating less subsequent run-off.


Our key role for the CRP project and management group has been in the areas of exploration planning and advice, data management and analysis, resource estimation advice and tenement management. In early 2014 Kenex completed 2 exciting pieces of work for CRP. These projects – development of a 3D geological model and a mineral prospectivity model – are being used by CRP to aid not only their exploration planning but also their environmental management aspirations. Two 3D geological models were built as part of the efforts to model the geological environments, nodular phosphate distribution and prospectivity over the central Chatham Rise. The purpose was to confirm and improve upon the existing geological knowledge of the region on both a local scale where the data density is relatively high, and regionally where only seismic data has extensive coverage. The regional model was used to establish parameters to constrain the potential regions of phosphatisation and nodule formation during the Early Paleogene and Neogene periods. The local scale model was built over the mining permit area, to refine structural and geological interpretations. This information was incorporated into the 2D prospectivity modelling.



Weights of Evidence and Fuzzy Logic prospectivity models have been undertaken, following on from the above discussed 3D geological modelling of the project area. Together these models are being utilised to facilitate the understanding of the resource distribution and extending key resource variables outside the mining permit, thus helping plan future exploration. The models collectively have also been used by RSC Consulting Ltd to aid geologically constraining a recently completed (March 2014) mineral resource estimate and preparation of JORC compliant technical report.


© Copyright 2014. Kenex   |    Legal Information